Pular para o conteúdo
14 dias de teste grátis, sem cartão10 idiomas176 tipos de negócio · 50 apps
PT· USD
Experimente uma demonstração ao vivoComeçar teste grátis

Este guia ainda não foi traduzido, por isso é exibido em inglês.

Fix a barcode scanner that types wrong characters

Use «Test scan» to see what the scanner sends, then fix the keyboard layout, prefix / suffix, Caps Lock or the GS1 separator.

Cerca de 1 minRevisado em

Antes de começar

  • Um espaço de trabalho zmle e um login com permissão para esta tarefa.

Passos

Onde: Devices & printers → This device → Barcode scanner

  1. Open Devices & printers → This device and scan one of the codes under «Test scan» (print the page if your scanner is a laser scanner).
  2. If «Check» says the characters are swapped by the keyboard layout, set «Keyboard layout» to «Always physical keys».
  3. If it shows a prefix or suffix, type it into «Prefix and suffix» (this device), or under the station's scanner rules for every device.
  4. If the GS1 separators are missing, switch on ‘transmit GS / FNC1 as Ctrl+]’ in the scanner's setup (its manual has a barcode for it).
  5. Scan again until «Check» says «Correct».

Dicas

  • Upper and lower case swapped: Caps Lock is on.
  • A Bluetooth scanner that loses characters: raise «Longest gap» for the station.

Algo errado?

Pergunte ao assistente com suas palavras ou fale com a equipe: respondemos por e-mail.

Isto foi útil?

Próximos passos

Ainda precisa de ajuda?

Pergunte ao assistente ou fale com a equipe, e respondemos por e-mail.