Vehicle inspection, damage map and grade: how it works
A seven-section inspection (exterior, interior, mechanical, electrical, tires and brakes, underbody, road test) with tire tread depth and age, OBD fault codes, damage marked on the car diagram and photos — giving a suggested grade A–E, a reconditioning estimate and a printed report.
Lesson 3 of 22 · How it works
How it works
Start an inspection on the car: every check is pass, advise, fail or not checked, with a note.
Tires: tread depth per wheel and the spare (below 1.6 mm is a fail, below 3 mm an advisory) and the DOT date code for the tyre's age; OBD-II codes such as P0420 are checked for their format.
Mark scratches, dents, cracks, chips and missing parts on the five views of the car diagram and add photos.
The grade is suggested from the results (frame or flood damage always E) and can be overruled; reconditioning lines (labor, parts, outside vendor) give the estimate used in the valuation.
Finishing locks the inspection and prints the inspection report with the damage map; a later change needs a new inspection.
Where to find it
- Stock & intake
/admin/car-dealer/stock
Checklist
Before you move on, check that you can:
- Open Stock & intake
- Start an inspection on the car: every check is pass, advise, fail or not checked, with a note.
- Tires: tread depth per wheel and the spare (below 1.6 mm is a fail, below 3 mm an advisory) and the DOT date…
- Mark scratches, dents, cracks, chips and missing parts on the five views of the car diagram and add photos.
- The grade is suggested from the results (frame or flood damage always E) and can be overruled;…
Tips and common mistakes
- A history check bought from an outside provider is typed into the road-test or summary notes — no history or VIN-decoder service is connected.
- The odometer reading at the inspection updates the car only when it is higher than the one on file.