Skip to content
14-day free trial, no card9 languages176 business types · 50 apps
EN· USD
Try a live demoStart free trial

Lane and court timers (billing by the hour): how it works

Timers bill a lane, court or room by the time it was actually used: start the timer on the resource board, stop it when the party leaves, and the time is billed per started block at the resource's hourly rate — to the till or onto a draft invoice.

Lesson 6 of 9 · How it works

  • about 3 min
  • Appointments → Resource board

How it works

  1. In Timer setup on the resource board set the hourly rate of each lane or court, the block length (e.g. 15 minutes), a short grace and the till product and till to use.

  2. Start the timer on a resource; the board shows the time running and the price so far. Only one timer can run per resource.

  3. Stop it when play ends: every started block is billed whole (a few minutes of grace after a full block are free).

  4. Send the amount to the till — it is parked there as a sale for the cashier to Recall The next routine check-up of a patient: last visit plus the interval (6 months unless set otherwise). More words in the glossary and take the payment — or onto a draft invoice for the booking's customer.

  5. Each timer is billed once; a mistaken timer can be voided before it is billed.

Where to find it

Settings that change it

Checklist

Before you move on, check that you can:

  • Open Appointments → Resource board
  • In Timer setup on the resource board set the hourly rate of each lane or court, the block length (e.g.
  • Start the timer on a resource; the board shows the time running and the price so far.
  • Stop it when play ends: every started block is billed whole (a few minutes of grace after a full block are…
  • Send the amount to the till — it is parked there as a sale for the cashier to recall and take the payment —…

Tips and common mistakes

  • No «To the till» button? Choose the till product in Timer setup first.
  • A resource without an hourly rate shows no timer.